To Rewire Outdoor Motion Sensor Light

Dec 5th

Outdoor motion sensor light – Motion-sensing lights automatically turn on lights when motion is detected. If this happens, replace the fixture. Rewiring outdoor motion sensor light is equal to a normal wiring, non-motion detection light. Many jurisdictions and municipalities require no fixed lighting to be completed by a qualified electrician. Check your codes for specific licensing requirements before beginning work.

Wonderful Outdoor Motion Sensor Light
Wonderful Outdoor Motion Sensor Light

Instructions to rewire outdoor motion sensor light: First, turn off the power switch on the main panel. Second, test the existing light switch is turned on, turn on the light “Test” way and to create movement. Test mode is probably the fixture itself. Test mode allows for exercise testing in daylight. When you are sure that the circuit is turned off, remove the existing fixture and discard. Unscrew it from the junction box plate with a screwdriver and twist off wire nuts.

12 Photos Gallery of: To Rewire Outdoor Motion Sensor Light

Image of: Wonderful Outdoor Motion Sensor Light
Image of: Top Outdoor Motion Sensor Light
Image of: Sweet Outdoor Motion Sensor Light
Image of: Pretty Outdoor Motion Sensor Light
Image of: Perfect Outdoor Motion Sensor Light
Image of: Outdoor Motion Sensor Light Style
Image of: Outdoor Motion Sensor Light Model
Image of: Nice Outdoor Motion Sensor Light
Image of: Good Outdoor Motion Sensor Light
Image of: Best Outdoor Motion Sensor Light
Image of: Beauty Outdoor Motion Sensor Light
Image of: Awesome Outdoor Motion Sensor Light
 

Third, connect the black sensor wire to the black Hothouse wire. Twist the new wire nuts. Connect the white sensor wire to the white neutral wire house. Connect the green house ground wire to green ground screw on fixture with a screwdriver. The screw can be labeled “Grand” or the like. Last steps to rewire outdoor motion sensor light, put the new fixture for the wall with the included screws and a screwdriver. Take care not to snag cables between luminaries housing and wall junction box housing. The circuit breaker back on and test.